How To Paint Your Car’s Plastic Bumper – Cheap Car Insur Brokers

How To Paint Your Car’s Plastic Bumper

Manufacturers are durable plastic bumpers to support the burden of occasional bumps and minor collisions. A bumper can take a lot of these small accidents without endangering structural damage. Though structurally strong, with each band neck and your bumper starts to look more banal. You can return to your good bumper shape painting on damage. Painting a plastic bumper requires intense preparatory work, including slight damage removal. When completed, however, the bumper should look fresh and almost new.

 Things you need

  • Screwdriver
  • compass keys
  • Auto foam bath
  • water Bucket
  • Sponge
  • Towel
  • Plastic solvent preparation
  • 80 abrasive paper
  • Plastic filling
  • 400 wet / dry abrasive paper
  • Elastic sealing part
  • HVLP sprayer
  • Primer in two parts
  • Adhesive cloth
  • Car Painting
  • Transparent coat paint
  • Hardening paint
  • 1500 damp / dry grain abrasive paper

 Instructions

  • Remove the plastic bumper of the machine. Various brands and models of cars attribute plastic bumpers of different ways; to find the fixing points, consult the manufacturer. In general, remove the plastic bumper cover by removing screws and bolts for the bumper metal underneath.
  • Clean the bumper with water and soap. Rinse the soap residues and dry thoroughly with a towel.
  • Use a plastic solvent preparation to clean the dirt, clean in the same direction along the entire bumper surface. Allow the solvent to dry completely before proceeding.
  • Scuff the surface of the bumper with granite 80 paper to create a rough surface that helps the new paint bond tie.
  • Locate the area on the rear of the bumper to identify the type of plastic that makes up the bumper to determine the required load repair. PP means bumpers in polypropylene, PPO is polyphenylene oxide, is a thermoplastic TPE elastomer, PUR rigid polyurethane plastic TPU and identifies as the thermoplastic polyurethane elastomer bumper. Notice the type of bumper.

  • Buy a plastic load in a car shop that fits your bumper type. Distribute the load to scratches on the bumper, fill the bumper surface. Wait 20 minutes for the load to harden and then continue with wet glass grain paper 400 to smooth the load.
  • Apply two-layer flexible bumper sealant to seal the surface and wait 30 minutes to dry.
  • Paint the bumper with two primer hands to dry the primer in your hands for about two hours. Use a HVLP sprayer to apply the paint. Make sure you get a picture that is rated for your type of plastic. Rent a sprayer from a home improvement shop or boutique rental facility. Sand the primer with 400 granules of wet sandpaper to smooth the lines and imperfections in the primer paint. Clean the polished bumper with an integrated wax tack cloth to remove the dust left by the sanding process.
  • Paint the paint primer on the bumper. Spray the base layer for painting the layer of layer after layer until you get the solid paint cover in the desired color. Allow the level to dry for 30 minutes.
  • Cover the base coat with transparent coating coat mixed with the catalyst. Follow the instructions to treat mixing reports. Cover the base layer with two layers of transparent paint to protect the new bumper damage. Provide two hours between one hand, so allow the bumper to sit overnight to dry completely drying.
  • Replace the plastic bumper for the machine, fixing it with screws and bolts removed. Moreover, if you found the job bit difficult then you can go for Chevrolet Silverado Replacement Bumpers as a quick fix.
  • Sand the surface of the transparent smooth layer with wet grain paper 1500. Remove all traces of the painting process. Poles and wax your bumper paintings cool as you would normally.